OGS Projected Capacitive Touch Screen Focaltech 5926 ISO9001 /
Touch Panel Specification:
216.96 x 135.6mm
253.96 x 168.6mm
|Driver Element||a-Si TFT active matrix|
1280 x 3(RGB) x 800
|Display Mode||Normally Black, Transmissive|
|Dot Pitch||0.0565(W) x 0.1695(H) mm|
|Active Area||216.96(W) x 135.60(H) mm|
Pixel Pitch (mm)
0.192 (H) x 0.192 (V)
R.G.B. Vertical Stripe
■ OGS structure
OGS uses one glass solution, directly form ITO conducting film in
the protective glass and use the sensor technology. It has the
advantage of the simple structure, light, thin and good
■ GG structure
GG structure is cover glass plus sensor glass technology solution,
with high transmittance, good effect of protecting scratch and also
harder than PG structure.
■ PG structure
PG structure uses one PET film plus sensor glass solution. Mature
process technology greatly reduces the failure rate and cost. It
has the same level weight with OGS structure.
IC: from Taiwan, America etc.
Film: from Japan, Korea etc.
Glass: from Japan, America, Germany etc.
- Tablet PC (MID)
- Smart phone
- Ultra book
- All In One (AIO)
- Car navigation (GPS)
- Education electronics
- Household appliance
- Bank system
- Smart home system
- Industrial equipment
finger contact area
high temperature and humidity
60℃, 90%RH, 96H
high temperature storage
-20℃(0.5H)~+70℃(0.5H) by 100 cycles
1, Do not exert extra force to touch panel.
2, Since touch panel is transparent and clear, make sure to wear
fingerstall or glove before touching.
Be careful of your hands and other parts from injury at handling by
3, When handling, make sure to hold the touch panel borders not
center parts to avoid dirt to touch
panel. Do not lift touch panel by tail to avoid tail loosen.
4, When installing and assembling, do not lift tail with heavy
force to avoid tail peeling off touch panel.
5, Do not stick or mount other parts on the tail, such as
additional film or metal plate. As it will exert
extra force to tail tip and cause tail loosen.
6, Please don't pull FPC with force from side to side, because the
FPC tension will make FPC burst.
7, If there is air groove on touch panel, when design product
structure, make sure no liquid and powder
near the air groove.
8, In order to avoid heavy stress to touch panel surface, make sure
to keep 0.2mm-0.5mm assembling
gap between touch panel and case.